Van toepassing op
On the CX-50, using the HDMI™ input after the Base Unit goes into standby results in the HDMI™ input not appearing on the screen.
This issue is only noticed with the ClickShare CX-50 Base Unit.
Upgrading your ClickShare Base Unit to firmware version 2.13 or higher will fix this issue.
Laatst bijgewerkt 21 mei 2024
Our helpdesk provides you with prompt phone support. A team of experienced support engineers is at your service for any professional assistance.
Our helpdesk provides you with prompt phone support. A team of experienced support engineers is at your service for any professional assistance.
Our helpdesk provides you with prompt phone support. A team of experienced support engineers is at your service for any professional assistance.
Our helpdesk provides you with prompt phone support. A team of experienced support engineers is at your service for any professional assistance.
