How can I configure and use displays in extended and clone mode with ClickShare CX-50 Gen2?

Artikelnummer: [7868]

Van toepassing op

kb7868_09.png
 

Dual display setup overview

  • Two displays
    Note: If a touchscreen display is used, make sure that it is connected to the USB Type-C™ port on the CX-50 Gen2.
  • CX-50 Gen2
Info! The extension/clone setting described in this article pertains to ClickShare specific settings and does not relate to the extension/clone that is known in the device screen settings.

 

Configuring Display mode settings

  1. Login to ClickShare Configurator of your CX-50 Gen2 (how to: KB 2324).
  2. Navigate to Display & Audio > Outputs.
  3. Select Extended or Clone from the Display mode drop-down list.
    kb7868_07.png

    When set Extended, an extra window available for source content to display. When set Clone, source content duplicated across two displays.
    The table below may assist you in selecting the mode "Extended or Clone" that suits your requirements.

Note: Make sure to always select ClickShare Position 1 in the ClickShare Configurator for the connected touchscreen display.

Note: If your CX-50 Gen2 is managed through XMS Cloud, you can also configure the Display mode settings via the XMS Cloud, for information see the chapter Base Units > Manage in the XMS Cloud User guide.

 

Sharing contents on dual display setup with CX-50 Gen2

  1. First user shares the content to the display using the ClickShare App or Button.
    Content will be duplicated across both displays.

    kb7868_03.PNG
     
  2. Second user shares the content to the display using the ClickShare App or Button.
    Depending on the Display mode configuration settings, one user content per display will be displayed or the user content will be duplicated on both displays

    kb7868_04.PNG
    Users content distributed on both displays

    kb7868_05.PNG
    Users content duplicated on both displays

 

ModesUsed forNo of sources
1 source2 sources
Extended (default setup)Presentation (Content)kb7868_ext_src1_pre.pngkb7868_ext_src2_pre.png
Conferencing (People and content) ¹kb7868_ext_src1_con.pngkb7868_ext_src2_con.png
Wired RoomDock ²kb7868_ext_src1_wr.pngNot applicable
ClonePresentation (Content)kb7868_clone_src1_pre.pngkb7868_clone_src2_pre.png
Conferencing (People and content) ¹kb7868_clone_src1_con.pngkb7868_clone_src2_con.png
Wired RoomDock ²kb7868_clone_src1_wr.pngNot applicable

 

¹  See KB 7894
²  See KB 7294

Swapping content between displays

The content of Display Port™ and the content of HDMI™ can be swapped. This can be useful if your displays are placed in a different order.
Go to Display & Audio and set the ClickShare Position for the DisplayPort and HDMI™ as required.

kb7868_06.png

Eigenschappen

Laatst bijgewerkt 10 mei 2024